Configure Icon As a Stand Alone Unit Remotely

Document created by blacanaria Support on Oct 3, 2016Last modified by blacanaria Support on Oct 3, 2016
Version 2Show Document
  • View in full screen mode


After performing a factory reset on a Icon Device. Below are the following commands that can be used to go through the initial configuration. The following commands can be used to get unit pass initial configuration.

 

RBSH Command:

 

rbsh> IR remoteIR 3 

{

  "_rv": 0

}

rbsh> IR remoteIR 3

{

  "_rv": 0

rbsh> IR remoteIR 3

{

  "_rv": 0

rbsh> IR remoteIR 1

{

  "_rv": 0

}

rbsh> IR remoteIR 4

{

  "_rv": 0

}

rbsh> IR remoteIR 4

{

  "_rv": 0

}

 

CLISH

control remote right

 

control remote right

 

control remote right

 

control remote down

 

control remote ok

 

control remote ok

 

or

 

control remote right right right down ok ok -d 500

3 people found this helpful

Attachments

    Outcomes